55kw 500kg/H Powder Crushing Machine For Wood Chaff

Wood Powder Mill Is Suitable For Wood Powder, Wood Chaff, Bamboo Powder, Chestnut, Elm Wood Powder

Wood powder machine is used for light weight materials, fiber materials, brittle materials, ductile materials and other special difficult grinding equipment.There are two crushing methods of wood flour mill, namely horizontal hammer mill and vertical roller mill

Roller grinding wood powder machine, centrifugal grinding and impact crushing, shearing, impact crushing, extrusion pieces as a whole, using fluid mechanics principle, can be made of wood, fiber, non-metallic mineral material grinding mill below 350 mesh, with good performance, high efficiency, low wear and tear, cover an area of an area small, easy to install, easy to operate, etc., product granularity index is good, stable performance.This machine is widely used for ultra-fine crushing of non-combustible and explosive materials with mohs hardness below 6.

In view of the pulverizer is the basic processing technology in the production and application of Traditional Chinese medicine, the superfine pulverizer has attracted more and more people's attention, although it started late, the varieties developed are relatively few, but it has revealed its unique advantages and broad application prospects.

Range of application

 wood powder, wood chaff, bamboo powder, chestnut, elm wood powder, wood grain, wood, leather grain, wood powder, cedar wood powder, dried small shrimps, anise powder, Chinese prickly ash, chili powder, pepper, refined cotton, feather, feather stalk, straw, wheat bran, rice husk, glued wood, potato ballast, cassava, Chinese herbal medicine, fish meal, cake, sanshui magnesium silicate, etc all fiber materials crushing process.

Is bakelwood, plastic, paper, mosquito-repellent incense, sanitary incense, feed, Chinese herbal medicine, breeding and other industries indispensable wood crushing equipment.

应用范围

With the extension of the service time, the machine often appears the following faults: the work is weak when crushing;Do not start;No electricity.Under normal circumstances can be self-maintenance.

First of all, check the power socket, plug, power cord whether there is no oxygen off, broken place, if not, you can plug in the power test machine, when the motor is powered on does not turn, gently dial the wheel disc can turn, it can be concluded that one of the two start capacitance of the machine caused by capacity failure.In this case, we usually have to change new products.The other case is the power does not rotate, but the external force can rotate but the motor gives out a weak current sound, which is caused by slight leakage of the starting capacitor.If the current noise is too large, the motor cannot be started at all. It is concluded that it is caused by the short circuit of the starting capacitor (the short circuit of the motor coil needs professional repair).In the absence of professional instruments, the capacitors (4UF/400V) can be removed first, and the two leads can be plugged into the zero and fire sockets of the mains power respectively to charge the capacitors, and then the two leads can be removed to short-circuit and discharge.If the discharge spark can be issued at this time and there is a loud "snap", the capacitor can be used;If spark and noise are weak, it indicates that the capacity of the capacitor has been reduced. You need to replace it or add a small capacitor.If the capacitor has been damaged short circuit can not be used, and must be replaced with the same specifications can be repaired.Another type is the rod mill high speed crusher, this crusher general quality is not easy to damage, and the daily maintenance is more important, the following is the maintenance of this type of crusher.Check the lubrication condition of the bearing

Noted: flammable and explosive materials prohibited to crushing!